000
2. Preparation
28
Using the Infrared Remote Control
When Using for the First Time
Pull out the insulating sheet from the battery
holder when using the supplied infrared remote
control for the first time.
Insulating sheet
A CR2025 lithium-ion battery is installed in the
battery holder at the factory.
Controlling the Camcorder Using the
Remote Control
To use remote control, first turn on the camcorder
and then enable remote control operation.
Use the setup menu to enable/disable the remote
control function.
To enable using the menu
Press the MENU button to switch the camcorder
to menu mode, then set IR Remote (page 74) in
the System menu to On.
[Notes]
Point the remote control at the remote control receiver
sensor on the camcorder.
Set up the camcorder so that the remote control receiver
sensor is not exposed to direct sunlight or strong light
from other sources. Strong light can prevent proper
remote control operation.
Other video decks may operate by mistake when using
the supplied remote control to operate the camcorder. In
this case, switch the remote control mode switch on the
video deck to DVD2, or shield the remote control receiver
sensor using black paper.
Changing the Battery of the Remote
Control
The remote control uses a standard CR2025
battery.
Do not use a battery other than the CR2025.
1 Push the tab in, and remove the battery holder
by placing a fingernail in the groove.
2 Insert a new battery with the + terminal facing
up.
3 Insert the battery holder until it clicks into
place.
Tab
[CAUTION]
Do not store battery packs in locations exposed to
direct sunlight, flame, or high temperature.
[Note]
Replacing the battery with a non-specified battery may cause
device failure. Always replace with the specified battery.
Dispose of used batteries in accordance with federal and
local laws.
To Next Page
