Sony RCC1000 - Controller Settings and Configuration; Password Change and Factory Reset; Speed, Sound, ID, and Lock Settings

______________________________________________________________________________
RCC1000
user manual | 6
Controller Settings
To view/modify the controller settings, press and hold down [Setup]. You will be
prompted to enter the controller password. Enter '8888' and press [Enter].
To scroll through the controller settings item, move the joystick left/right. Press [Enter] to
view/modify a particular setting.
1 EDIT PW - To change the controller password:
You will be prompted to enter the old controller password. Enter the old password
(factory default is '8888') and press [Enter]. You will then be prompted to enter the new
password. Enter the new password and press [Enter]. Re-enter the new password again
when prompted and press [Enter].
2 FACTORY - To revert controller to default factory settings:
You will be asked to verify that you want to revert to default factory settings. Press
[Enter] to proceed or [Esc] to abort.
3 SET SPEED - To set the pan/tilt speed range:
Move joystick left or right to select HIGH or LOW or MEDIUM. Press [Enter] to select a
speed range. Press [Esc] to save selection and return to controller settings menu.
4 SOUND - To turn the key-press sound ('beep') on/off:
Move joystick left or right to select SOUND OFF or SOUND ON. Press [Enter] to make
selection.
5 KB ID: To assign an ID to the controller:
Enter a number [0] - [15] and press [Enter].
6 LOCK SET - To lock camera function keys on controller:
Move joystick left or right to select LOCK OFF or LOCK ON. Select LOCK ON and
press [Enter]. You will be prompted to enter a Lock Password (LOCK PW). Enter a 4-
digit password and press [Enter].