Sony RCC1000 - Camera Control and Functions; Camera ID Management; Preset Setup and Recall

______________________________________________________________________________
RCC1000
user manual | 8
Assigning Camera IDs
Assigning a Camera ID for single camera use:
Connect camera to controller, camera ID will be set as '1' automatically after powering
on both camera and controller.
Assigning a Camera ID for multiple cameras:
Connect first camera to controller and subsequent cameras in a daisy chain
configuration. Press and hold [SetID] for 2 seconds. Camera IDs will be set in sequence
as '1', '2', '3', etc.
Selecting a Camera ID
When controlling multiple cameras, to select the camera you would like to control, press
[Cam], enter camera ID number, press [Enter]
For example, to select Camera 2: Press [Cam], Press [2], Press [Enter]
Setting Up and Recalling Camera Preset Positions
Setting Up a Preset Position
Select camera ID and press [Preset]. Adjust the camera to desired position and zoom,
key in a number for this preset (e.g., 1, 2, 3 ...) and press [Enter]. Repeat steps to setup
other presets or press [Esc] to exit.
Recalling a Preset Position
Select camera ID and press [Call]. Key in the preset number and press [Enter]. Repeat
steps to recall other presets or press [Esc] to exit.