24
GB
Executing a Series of Commands
— System Control Functions
(continued)
To programme a new series of
operations for buttons which have
already been set
SYSTEM CONTROL A or C button:
Erase the factory preset programme
(page 26).
Other buttons:
Erase the programme (page 25).
3 Press the Component Select
buttton (in the case, TV) for the
component to operate.
The keys for the selected component
flash.
If the component has the power-
on and power-off signals
Both the OFF and ON keys are displayed
and you can select either of them to
program.
It is useful to set the exact command for
power-on or power-off and operate the
component regardless of its status (on/off).
4 Press key(s) or button(s) for the
desired operation.
If you want to power on the TV, press
the 1 key.
5 Repeat Steps 3 and 4 and
programme the buttons and keys
for the series of operations.
In this example, press the following
buttons and keys.
6 When you have programmed all
the keys, press COMMANDER
OFF.
To Next Page
Loading...
