41
GB
Selecting a Channel
with a Single Key Press
— Channel Macro Function
You can programme the Channel Macro
function for the keys listed below (macro
keys).
If you programme the operation of
entering the 1, 2, 3 and ENTER keys for a
macro key, you can select the channel 123
by pressing that single key.
Component Macro key
TV: PIP STILL, PIP TEXT, PIP
CH+, PIP MOVE, PIP
SWAP, PIP CH-
CBL: m, N, M, REC*, x, X
SAT: m, N, M, REC*, x, X
* You can programme this function for REC
key alone (not on the REC + B key for a
double-key operation).
TV
CD MD
SAT VCR
TAPE
DVD
M1
CBL
M2
AMP
M3
PROGRAM
2
1
5
To receive the data of a
Component Select button from
another remote commander
1~2 Perform Steps 1 and 2 on page
40.
3 Press the 2 key.
4 Press the Component Select
button to which want to assign
the data.
5 Press the ENTER key.
When the data have been received,
“TV” and “r” go off. If the data have
been successfully received, the
backlight of the display turns off.
Notes
• If the Commander is not ready for
receiving the data, press CLEAR key, then
OK key to clear the learned signal on all
or one of the Component Select buttons.
• If “NG” appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending remote
commander again to send data.
Continued
To Next Page
Loading...
Need help?
General
