13
GB
Example: To play a CD player
1 Press the desired Component
Select button.
The Commander comes on and the
keys for operating the selected
component are displayed.
Operating Your
Components with the
Remote Commander
When you operate a non-Sony
component, make sure you set the
component code first (page 8).
TV
CD MD
SAT VCR
TAPE
DVD
M1
CBL
M2
AMP
M3
PROGRAM
1
2
3
Continued
2 Press the desired key in the
touch-key display.
When the remote control signal is
sent, is shown on the display.
You may also use the w +/– buttons,
the MUTING button and the
PROGRAM +/– buttons if necessary.
See “Table of Preset Functions” (page
59) for the functions of keys and
buttons for each component.
3 When you are done using the
Commander, press
COMMANDER OFF to power off
the Commander.
Note
The remote control signals may be different for
some components or functions. In this case,
programme the remote control signals with the
learning function (page 15). Note, however,
that components and functions that do not
support the remote control of infrared signals
will not work with this Commander.
To Next Page
Loading...
Need help?
General
