33
GB
3 Press the desired Component
Select button.
The selected component name stays
lit and “LEARN” flashes.
4 Press and hold down the button
on the component’s remote
control (amplifier in this example)
until you hear a beep.
(If you release the button before
you hear a beep, the signal may
not be learned correctly.)
“LEARN” stops flashing and stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and 4
again.
5 Press COMMANDER OFF.
To clear the learned function of
the Component Select button
1 While pressing COMMANDER OFF,
press PROGRAM + and w +.
2 While pressing the LIGHT button,
press the Component Select button
which you want to clear.
Notes
•You can programme a signal by “learning”
for a Component Select button for which a
System Control function (page 27) or the
Power-On function (page 30) has been
programmed. In this case, the System Control
function or the Power-On function is
overwritten and cannot be used. If you clear
the “learned” signal from the button, the
System Control function or the Power-On
function is resumed, and you can use it again.
•You cannot programme a System Control
function (page 27) for a Component Select
button for which a signal has been
programmed by “learning.”
•You can programme the Power-On function
for a Component Select button for which a
signal has been programmed by “learning,”
but then the Power-On function cannot be
used. If you clear a “learned” signal from the
button, you can use the Power-On function.
To Next Page
Loading...
