Sony RM-VZ950T User Manual

27
GB
Continued
Example: To change “VCR” to
“SONYDV”
1 Press SET, turn the Jog dial
to select “NAME,” then
press the Jog dial.
The Setting position number
flashes, and the component
name appears in the display.
The Commander changes to
the NAME mode.
Note
If you already have changed the
name of the component, that name
is displayed.
Tips
• It is recommended that you look
at your note on the component
code list when write the names.
• If you press the Jog dial at
“EXIT”at any point during
operation, the Commander
returns to the previous mode.
2 Turn the Jog dial to select
the component name you
want to change, then press
the Jog dial.
The component name flashes
in the display.
If you want to change the name
of the amplifier’s input source,
press the Jog dial again.
The input source name flashes
in the display.
3 Press the Jog dial.
A cursor flashes on the first
character of the component
name.
4 Turn the Jog dial to select a
desired character.
The selected character and the
cursor flash in turn.
-1S
MENA
VT
-3S
R
MENA
CV
MPA
DE
MENA
IVO1
-3S
R
MENA
CV
-3S
CR
MENA
VS

Sony RM-VZ950T Specifications

General

Brand	Sony
Model	RM-VZ950T
Category	Remote Control
Language	English