29
GB
To reset the name of the
component back to the initial
factory preset
Example: To reset the changed
name at “S-3” to the factory
preset
1 Follow Steps 1 to 2 on page
27. Then turn the Jog dial to
select “INIT.”
“INIT.” flashes in the display.
2 Press the Jog dial.
The factory preset component
name of the selected Setting
position number flashes in the
display.
If you want to reset the names
for other Setting position
numbers, turn the Jog dial to
select “EXIT,” press the Jog
dial, and repeat from Steps 1 to
2.
3 Select “EXIT,” then press
the Jog dial to finish setting.
Tip
You can also press b/B instead of
turning the Jog dial to the left/right.
You can also press OK instead of
pressing the Jog dial.
-3S
IT
MENA
NI.
-3S
R
MENA
CV
Jog
dial
To Next Page
Loading...
Need help?
General
