6-19
Code Description
A1
At the mode change command, the mode could
not be changed within specified time and the
drive stopped.
A2
Retry due to supply error failed and the drive
stopped.
A3
Disc directory configuration and information
file are illegal and the drive stopped.
A4 The drive stopped as a DVD-R disc was used.
A5
Coded data could not be decoded and the drive
stopped.
A6
At slow R, the destination of reverse search is
illegal and the drive stopped.
A7
Information file reading failed and the drive
stopped.
B0 SYSCON error was due to supply system.
B1 SYSCON error was due to VIDEO hung up
B2 DMX error
B3 At slow R, data supply time out
B4 At slow R, wrong Navi Pack sector address
B5 At slow R, VIDEO hung up
B6 At slow R, Gttgt end time out
B7 At FF/FR, data supply time out
B8 At FF/FR, VIDEO hung up
C0 IFCON ROM destination is wrong
C1 IFCON UART1 communication port NG
D0
The power turned off because of power off
request from drive controller.
D1
The mode change to Stop mode failed and the
power turned off.
E0 DRVCON system error
E1 DRVCON system error
2 DISC TYPE
Code Description
FF Unknown
00 No Disc
01 CD 12 cm
11 CD 8 cm
02 Single DVD 12 cm
12 Single DVD 8 cm
03 Dual DVD 12 cm
13 Dual DVD 8 cm
04 CDR 12 cm
14 CDR 8 cm
05 DVDR 12 cm
15 DVDR 8 cm
6-19 E
2. Each user needs to contact
with the service section ............................................ “E” code
1 EMG CODE
2 DISC TYPE
1 EMG CODE
Code Description
01 EEPROM (IC801) Write NG
02 EEPROM (IC801) Read NG
03 EEPROM (IC801) Busy Time Out
04 Emergency History Pointer NG
06 IFCON SYSCON Communication NG
07 IFCON V-sync NG
10 EEPROM (IC801) Check NG
16 DSP (IC506) Check NG
20 Home Position Time Out
21 Sled Driver NG
26 Tray NG
27 Roulette NG (Not used)
30 Hy Det Level NG
31 Sled Offset Cancel NG
32 Focus Gain NG
33 Tracking Offset NG
34 Tracking Gain NG
35 Jitter NG
40 Focus Servo Lock NG
41 Focus Jump NG
60 Miss Chuck
61 Spindle Lock Time Out
62 Spindle Reckless
63 CLV Lock NG
64 CLV Lock Time Out
65 CAV Speed NG
66 Spindle Speed × 1 NG
70 Req Address NG
71 Req Time Code NG
72 Req Track No. NG
73 Seek NG
80 Address Continuity NG
81 Address Read NG
82 TOC Read Time Out
83 – 87 Physical Information Read Error
88 Layer No. NG
89 CD Text Data Read Error
90 Recovery NG
96 Auto Sequence Time Out
97 Auto Sequence Fail
A0 Stop request from drive controller was received
E : :
12
To Next Page
