Hooking Up the Audio Components
Use an optical digital cable for this connection. When connecting
the optical digital cable to the DIGITAL (CD) OUT OPTICAL
connector, take the cap off the connectors and push the cable
plugs in until th’ey click into place.
Be careful not to bend or twist the optical cable.
Optical digital cable (not supplied)
Note
Only the audio signals of conventional CDs can be output from
the DIGITAL (CD) OUT connector. Those of the Super Audio CD
cannot be output through DIGITAL (CD) OUT.
b
Use an coaxial digital cable to connect the audio components
equipped with coaxial digital input connectors.
Coaxial digital cable (not supplied)
Note
Only the audio signals of conventional CDs can be output from
the DIGITAL (CD) OUT connector. Those of the Super Audio CD
cannot be output through DIGITAL (CD) OUT.
Connect the AC power cord to a wall outlet
If you have a Sony component with the
CONTROL
AlJl (or CONTROL Al) jack
Connect the component via the CONTROL AlJI (or CONTROL
Al) jack with a monaural (2l’) mini-plug cord. You can simplify
the operation of audio systems composed of separate Sony
components. For details, see “Using the CONTROLAlII Control
System” on page 26.
You can set the supplied remote to be effective on this player only
by changing the command mode of the remote.
If you connect this player to another Sony CD player, you have to
set the command mode of each player.
To set the command mode of the remote
l
If the other player’s command mode can be set:
Set the CD1/2 switch of this player’s remote to CD1 (factory
setting), and set the other player’s remote to CD2.
l
If the other player’s command mode cannot be set:
Set the CD1 12 switch of this player’s remote to CD2.
To set the command mode of this player
Press MENU.
Turn Kkl AMS DDO to select “COMMAND MODE.”
Push K-4 AMS DO!.
The
current command mode appears.
Turn lKKl AMS DDI to select CD1 or CD2, then push
w<l AMS DLX again.
Before transporting the player, follow the procedure below to
return the internal mechanisms back to their original position
1 Remove all the discs from the disc tray.
2 Press a OPEN/CLOSE to close the disc tray.
“No Disc” appears in the display.
3 Wait for 10 seconds, then press POWER to turn off
the player.
6
US
To Next Page
Loading...
