Sony SLV-SE410 User Manual

SERVICE MANUAL
AEP Model
SLV-SE310D/SE510B/D/SE510D
UK Model
SLV-SE310I
East European Model
Russian Model
SLV-SE410K/SE510K
VIDEO CASSETTE RECORDER
SPECIFICATIONS
Photo: SLV-SE510
– Continued on next page –
S MECHANISM
SLV-SE310/SE410/SE510
RMT-V257B/V257C
The abbreviations of SE310/SE410/SE510 contained in this service manual are indicated
when these models are common to all their corresponding models as given below.
SE310D
SE310I
SE410K SE510B
SE510D
SE510K
SE310 SE410 SE510
Abbreviated
models name
All model names
SLV-
System
Channel coverage
P
SLV-SE410K/SE510K
AL (B/G, D/K)
VHF E2–E12, R1–R12
UHF E21–E69, R21–R69
SLV-SE310D/SE510D
SLV-SE510B
CATV S1–S41, S01–S05
RF output signal
UHF channels 21–69
Aerial out
75-ohm asymmetrical aerial socket
Tape speed
SP: PAL/MESECAM
23
SECAM 23.39 mm/s
(recording/playback)
SECAM 11.70 mm/s
(recording/playback)
.39 mm/s (recording/playback)
NTSC
33.35 mm/s (playback only)
LP: PAL/MESECAM
11.70 mm/s (recording/playback)
NTSC
16.67 mm/s (playback only)
EP: NTSC
11.12 mm/s (playback only)
PA
SLV-SE310I
PAL (I)
VHF IA to IJ, SA10 to SA13
UHF B21 to B69
CATV S01 to S05, S1 to S20
HYPER S21 to S41
L(B/G)
VHF E2 to E12
VHFItalianchannelAtoH
UHFE21toE69
CATVS01toS05,S1toS2
0
H
SECAM (L):VHF F2 to F10
UHF F21 to F69
CATV B to Q
HYPER S21 to S41
PAL (B/G) :VHF E2 to E12
VHF Italian channel A to H
UHF E21 to E69
CATV S01 to S05, S1 to S20
HYPER S21 to S41
YPERS21toS41
• Refer to the SERVICE MANUAL of VHS MECHANICAL
ADJUSTMENTS VI for MECHANICAL ADJUSTMENTS.
(9-921-647-11)

Sony SLV-SE410 Specifications

General

Brand	Sony
Model	SLV-SE410
Type	VCR
Video Heads	4
Recording System	NTSC
Playback Speed	SP, LP, EP
Audio System	Mono
Remote Control	Yes
Connections	Composite video output, RCA audio output

Summary

Service Manual Introduction and Specifications

Model Identification and Technical Specifications

Details model variations, channel coverage, and tape speed specifications for the VCR.

Safety and Operational Guidelines

Component Safety Warnings and Service Checks

Highlights critical components, safety warnings, and essential post-repair check procedures.

General Specifications and Accessories

Lists general operating parameters, dimensions, mass, and supplied accessories for the unit.

Disassembly Procedures

Disassembly Flowchart and Sequence

Visual guide outlining the order of disassembly for various VCR components.

External Component Removal (Case, Panel, Block, Rear)

Detailed steps for removing the upper case, front panel, power block, and rear panel.

Mechanism Deck and MA-401 Board Removal

Instructions for removing the mechanism deck, MA-401 board, and related parts.

Internal Component and Board Identification

Internal Component Layout Diagrams

Illustrations showing the arrangement of major internal components like the drum and motors.

Circuit Board Location Diagrams

Diagrams indicating the placement of the MA-401 board and power supply unit.

Troubleshooting and Adjustments

Error Code Reference Guide

Lists error codes, their meanings, and associated mode indications for troubleshooting.

Mechanical Adjustment Reference

Reference to external manual for mechanical adjustments and required alignment tapes.

Electrical Adjustment Preparation and Setup

Details required equipment, connections, and general setup for electrical alignments.

Power Supply Voltage Verification

Procedures for verifying critical power supply voltages on the MA-401 board.

Audio and Servo System Calibration

Steps for adjusting servo system RF switching and various audio parameters.

Adjustment Component Location Diagram

Diagram identifying specific components on the MA-401 board used for adjustments.