Why does my Sony SNAPLAB UP-CR20L Printer have a vertical white stripe on the printout?
If a vertical white stripe appears on the printout from your Sony Printer, it might be due to dust accumulation on the thermal head. To resolve this, clean the interior of the printer.
Why is my Sony SNAPLAB UP-CR20L not feeding paper correctly?
If your Sony Printer isn't feeding the paper correctly, there are a couple of things to check: * First, make sure the printer is turned on. If it isn't, turn it on. * Second, verify that the paper roll is loaded in the correct direction. If you loaded it with the left and right sides reversed, reload it properly.
What to do if my Sony SNAPLAB UP-CR20L says 'Out of paper' but there is still paper?
If your Sony Printer displays an 'Out of paper' message even when there's still paper in the unit, don't worry, it's not a defect. Some spare paper will always be left over. Remove the leftover paper and load a new ink ribbon and paper roll.
What to do if my Sony Printer says 'no paper' after loading paper?
If you've loaded the paper roll in your Sony Printer, but a 'no paper' message appears, it might not have been loaded correctly. Ensure that the paper roll is loaded correctly.
What to do if my Sony SNAPLAB UP-CR20L says 'no ink ribbon' after loading ink ribbon?
If you've loaded the ink ribbon in your Sony Printer, but a 'no ink ribbon' message appears, the ribbon may not have been loaded correctly. Ensure that the ribbon is loaded correctly.
How to fix white margin on printed image with Sony SNAPLAB UP-CR20L?
If there is a white margin on the printed image from your Sony Printer, it may be because you're using a 127 mm (5 inches) wide printing pack (2UPC-R203/ R205 series) without the paper adapters attached. Attach the paper adapters to resolve this issue.
What to do if I cannot load paper roll in my Sony SNAPLAB UP-CR20L?
If you cannot load the paper roll into your Sony Printer, check if you are trying to load a printing pack that is 152 mm (6 inches) in width (2UPC-R204/ C26/R206 series) while the paper adapters are attached. If so, remove the adapters and then load the paper roll.
General| Print Size | 4 x 6 inches |
|---|---|
| Print Resolution | 300 x 300 dpi |
| Power Supply | AC 100-240V, 50/60Hz |
| Print Technology | Dye Sublimation |
| Connectivity | USB 2.0 |
| Operating Temperature | 50-95°F (10-35°C) |
| Operating Humidity | 20% to 80% (non-condensing) |
To Next Page
