Sony STR-DE405 - Antenna Hookups; Audio Component Hookups

ae a eee
Antenna Hookups
Overview
This section describes how to connect AM and FM
antennas to the receiver. If you want to receive radio
broadcasts with the receiver, complete these
connections first, then go to the following pages.
For specific locations of the terminals, see the
illustration below.
ANTENNA
What antennas will | need?
¢ FM wire antenna * AM loop antenna
(supplied) (1) (supplied) (1)
Hookups
FM wire antenna Receiver AM loop antenna
After connecting
the wire
antenna, keep it
as horizontal as
possible.
o If you have poor FM reception
Connect a 75-ohm coaxial cable (not supplied) to an FM
outdoor antenna. Pull back the mesh portion
surrounding the inner cable and connect it to the earth
terminal (right side). Connect the inner cable to the FM
terminal (lett side).
Receiver
ANTENNA
we
If you have poor AM reception
Connect a 20 to 50 ft. (6 to 15-meter) insulated wire (not
supplied) to the AM antenna terminal in addition to the
AM loop antenna. Try to extend the wire outdoors and
keep it horizontal.
a Getting Started
Connecting a ground wire
To prevent hum, connect a ground wire (not supplied)
to the 4 ground terminal. If you've connected an
outdoor antenna, be sure to connect the ground for
lightning protection.
Receiver
ANTENNA
to ground
Where do | go next?
Ifyou want to connect other components, go or to the ext
section. If you're only planning to use te receiver to tsten
to the radio, go to “Speaker System Hookups” on pages ©
and 7
Da a |
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If vou want to use the
receiver as an amplifier, complete these connections.
For specific locations of the jacks, see the illustration
below.
PHONO TAPE/MD
What cords will } need?
Audto cords (not supplicd) (1 for each CD player or
turntable; 2 for each tape deck or MD recorder)
> White (L)
> Red (R)
(continued)