Sony STR-DH820 - Specifications Overview; AUDIO POWER SPECIFICATIONS; Amplifier section specifications

93
GB
D:\NORM'S JOB\SONY HA\SO0129\STR-DH820_PMRF_01\4266497112_GB\GB07ADD_STR-
DH820-CEL.fm
masterpage: Right
STR-DH820
4-266-497-11(2)
Additional Information
USB FAIL
An over current from the (USB) port was
detected. The receiver will automatically
turn off after a few seconds. Check the
iPhone/iPod or USB device, then unplug it
and turn on the power again.
For other messages, see “Message list after
Auto Calibration measurement” (page 40),
“iPhone/iPod message list” (page 47) and
“USB message list” (page 50).
Reference sections
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(USA model only)
With 8 ohm loads, both channels driven, from
20 Hz – 20,000 Hz; rated 100 watts per
channel minimum RMS power, with no more
than 0.09% total harmonic distortion from
250 milliwatts to rated output.
Amplifier section
USA model
1)
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
100 W + 100 W
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
110 W + 110 W
Surround Mode Output Power
2)
(8 ohms, 1 kHz, THD 10%)
150 W per channel
Canada model
1)
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
95 W + 95 W
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
110 W + 110 W
Surround Mode Output Power
2)
(8 ohms, 1 kHz, THD 10%)
150 W per channel
Europe, Australia and Taiwan models
1)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
100 W + 100 W
Surround Mode Output Power
2)
(8 ohms, 1 kHz, THD 10%)
140 W per channel
Clearing the memory
To clear See
All memorized settings page 34
Customized sound fields page 58
continued