9
US
Supplied accessories
• Operating Instructions (this manual)
• Quick Setup Guide (1)
• Remote control (RM-AAP102) (1)
• R6 (size AA) batteries (2)
• FM wire antenna (aerial) (1)
• AM loop antenna (aerial) (1)
• Optimizer microphone (ECM-AC2) (1)
Insert two R6 (size-AA) batteries
(supplied) in the remote control. Observe
the correct polarity when installing
batteries.
• Do not leave the remote control in an extremely
hot or humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds
of batteries.
• Do not expose the remote control sensor to
direct sunlight or lighting apparatuses. Doing so
may cause a malfunction.
• If you do not intend to use the remote control for
an extended period of time, remove the batteries
to avoid possible damage from battery leakage
and corrosion.
• When you replace or remove the batteries, the
programmed codes may be cleared. If this
happens, reprogram the remote control
(page 108).
• When the receiver no longer responds to the
remote control, replace all the batteries with
new ones.
Inserting batteries into
the remote control
Notes
To Next Page
Loading...
