Sony SX-M700 - User Manual

155 pages

Save Page as PDF

To Next Page

CONTROL UNIT

EXPANSION UNIT

EXPANSION BOARD

SERVICE MANUAL

2nd Edition

TELEPHONE COUPLER

SX-M100 J 11001 and Higher

U 21001 and Higher

EK 51001 and Higher

SX-M700 J 11011 and Higher

U 21001 and Higher

EK 51001 and Higher

SX-M100

SX-M700

SX-E120

SXA-120

SX-T100

SX-E120 J 11001 and Higher

U 21001 and Higher

EK 51006 and Higher

SX-T100 10001 and Higher

SXA-120 11001 and Higher

Main Page

Questions and Answers

R
Randy SmallAug 25, 2025
What to do if the microphone indicator keeps blinking on Sony Control Unit?
- M
  Margaret DelgadoAug 25, 2025
  If the microphone indicator and MIC ON/OFF button on your Sony Control Unit's chairman/delegate units are blinking, it could be due to several reasons: 1. Incompatible units are connected. If you are configuring a simultaneous conference system, make sure to use only SX-C700A/D700A/C750/D750 units. 2. Too many units are connected in series. Make sure that no more than 16 units are connected to one DELEGATE’S/CHAIRMAN’S connector. 3. A unit or connecting cable is defective. Try disconnecting the first blinking unit, replacing the connecting cable, or replacing the defective unit.
J
James CollinsNov 8, 2025
Why are the microphone indicator and MIC ON/OFF button blinking on my Sony Control Unit's chairman/delegate units?
- W
  William ReynoldsNov 8, 2025
  The blinking of the microphone indicator and MIC ON/OFF button on the chairman's or delegate's unit of your Sony Control Unit usually indicates a problem with the connected units or cables. Here are a few possible causes: * Incompatible Units: Ensure that you are only using SX-C700A/D700A/C750/D750 units for a simultaneous interpretation conference system. Mixing them with SX-C100A/ D100A/C150/D150 units can cause this issue. * Too Many Units: Check that you have not connected more than 16 units in series to one DELEGATE’S/CHAIRMAN’S connector. Disconnect any units beyond the 16th. * Defective Unit: The first unit blinking may be defective. Try disconnecting it. If the blinking stops on subsequent units, the disconnected unit is likely the problem. Remove or replace it. * Broken ...