Sony TA-2000F - Page 4

TA-2000F
SECTION 1
TECHNICAL DESCRIPTION
1-1. TECHNICAL SPECIFICATIONS (LOW : greater than 50dB
Technical
specifications
for
the
TA-2000F
are
LEVEL)
(weighting
given in Table 1-1. network B)
PHONO 2 : greater than 73 dB
TABLE 1-1. SPECIFICATIONS , (weighting
‘ network A)
e : +
Frequency PHONO-1, 2: RIAA curve +0.5 dB MIC ‘renter shan s0dB
response: MIC : 30Hz to 30kHz ichti
+9 dB (weighting
network B)
TUNER, TUNER
AUX 1, 2,3 :
mapneie 3 10Hz to 100kHz AUX 1, 2, 3] greater than 90 dB
> 40 TAPE 1, 2 (weighting
REC/PB 42 dB
; REC/PB network A)
(input) (input)
Input sensitivity PHONO-1 =: 1.2mV 33k Tone contole +10dB at 50Hz
and impedance: (HIGH LEVEL) 47k : (TURNOVER
os ve FREQ. 250 Hz)
(LOW LEVED 0.06mV 10 ohm AS$ +10dB at 100 Hz
30 ohm (TURNOVER
PHONO-2_ : 1.2mV_.s 47k FREQ. 500 Hz)
MIC :0.5mV_ 100k ; +10dB at 10kHz
TUNER
(TURNOVER
AUX
1,
2,
3
FREQ.
2.5
kHz)
eee TREBLE
TAPE 1,2 $110mV_ 100k +10dB at 20kHz
REC/PB
(TURNOVER
(input)
FREQ.
5
kHz)
Maximum input PHONO-1 Filters: LOW: 12dB/oct, below 50Hz
capability: (HIGH LEVEL) : 300mV HIGH: 12 dB/oct, above 9 kHz
(LOW LEVEL) : 1I5mV Harmonic Less than 0.03% at rated output,
PHONO-2 > 300mV distortion: 1 kHz
MIC :1,200 mV
IM distortion: Less than 0.05% at rated output
Signal output OUTPUT :1V 3k (60 Hz:7 kHz = 4:1)
level and 1, 2 :0.3V 6k
impedance: REC OUT :100mV_ 10k : Power
{2 (max 30V) consumption: 23 watts
‘CENTER :5V 2.6k Power 100, 117, 220 or 240V ac,
HEADPHONE : 0.5V requirements: 50/60 Hz
OUT (8 ohm load)
REC/PB : 30mV 82k Dimensions: 400 mm (width) x 149mm
(output) (height) x 315 mm (depth)
1534,” (width) x 51346" (height) x
Signal-to-noise PHONO |! 1274" (depth)
ratio: (HIGH : greater than 73dB ;
network A) Shipping weight: 11.2kg (24]b 120z)