Sony TA-F45 Service Manual

TA-F45
AMPLIFIER SECTION
Power Output and Total
Harmonic Distortion:
(US, Canadian model)
Continuous RMS Power
Output:
(Less than 0.008% THD,
both channels driven
simultaneously)
{AEP, UK mode!)
Power Bandwidth:
(IHF)
Harmonic Distortion:
Intermodulation (IM)
Distortion:
(60Hz : 7kHz = 4: 1)
Frequency Response:
Residual Noise:
Dampting Factor:
Inputs:
With 8 Q loads, both channels driven, from
20 — 20,000 Hz; rated SOW per channel
minimum RMS power, with no more than
0.008 % total harmonic distortion from
250 mW to rated output.
| Maximum S/N
_ | input
Sensitivity: Impedance | capability
|
|
(TkHz)
Setting of the
CARTRIDGE
LOAD
selector
(weighting
network, -
input Jevel)
| 90 dB
: 78dB*
(A, 2.5 mV)
At 20 — 20,000 Hz
50W + 50W (8 2)
According to DIN 45500
50 W + 50 W (8 2)
5 — 30,000 Hz (AEP, UK model) (A, 0.25 mV)
104 dB
78 dB*
(A, 150 mV)
Less than 0.008 % at rated output 150 mV 50 kN
Less than 0.006 % at 25 WY output
Less than 0.008 % at rated output * "78 IHF
Less
than
0.006
%
at
25
WV
output
Measured
with
rated
output
cower
into
8-ohm
loads
(both
channels
driven
PHONO RIAA equalization curve +0.2d8 simultaneously) at 1 kHz
TUNER
AUX 5 — 70,000 Hz Ae dB Outputs:
TAPE 1,2
Less than 130 uV (8 2, Network A) Impedance
50 (8 2, 1 kHz)
(—14.5 aB)
SPEAKER
A,B
HEAD-
PHONES
Accepts speakers cf 2-162
Accepts low ard hich impedance headphones.
BASS = 10 4B at 100 Hz
(turnover frequency: 500 Hz)
TREBLE =10dB at 25 kHz
(turnover frequency: 5 kHz)
Tone Controls:
Loudness: +1008 at 100 Hz, +3 dB at 10 kHz
(att. 30dB)
Low Filter: 6 dB/octave attenuation below 15 Hz
0dB=0.775 V
MODEL IDENTIFICATION
Specification Label
INTEGRATED STEREO AMPLIFIER |
MODEL NO. TA—F45
ae
MADE IN JAPAN {
aes
SERIAL NO.
US modei AC 120V 60Hz SOW
Canadian mocel : AC 120V 60Hz 140W
AEP modet AC 220V ~50/60Hz 220W
UK model AC 240V ~650/60Hz 260W

Sony TA-F45 Specifications

General

Brand	Sony
Model	TA-F45
Category	Amplifier
Language	English