Sony TC-K555ES - MECHANICAL ADJUSTMENTS - HEAD BASE POSITION; Head Base Position Adjustment

TC-K555ES
Head Base Position Adjustment
Perform the following adjustment when replacing the
head
base solenoid.
Perform with the old head base solenoid still in
place.
1. Press the head base solenoid core with the
finger until the head base stops moving.
2. Draw a line as shown in Figure 2. Replace with
the new head base solenoid.
3. Loosen
the mounting screw, match with the
line drawn in step 2, and tighten the screw.
4. Lock
the screw after adjustment.
L-_..-L~;---- draw a line
head board
~..--_,.--: .. ~- -"?
~ ...
, ,
, ,
_...L __ .L_,
X:
I
I
I
I
I
I
X I
I
__ ..J
core
screws
head base solenoid
Fig. 1
head board
Jz. mech chassis
Fig. 2
head base position adjustment
-20-