Sony TC-WAS8ESA - Page 17

Advanced Recording Operations
7
Press
SYNCHRO.
Notes
* To prevent interruption of the recording process, do not
press any operation buttons on the CD player during CD
If your CD player has the Peak Search function: Synchro-Recording.
The
SYNCHRO
button
indicator
lights
up
and
the
CD
*
Certain
operation
buttons
on
the
tape
deck
are
disabled
player
locates
the
highest
signal
level
among
the
tracks
during
CD
Synchro-Recording.
to be recorded as the tape deck adjusts the recording
level. When the recording level adjustment is
completed, CD Synchro-Recording starts.
If your CD player does not have the Peak Search
function:
The CD player changes to play pause and deck B to
recording pause. Press PAUSE If on deck B to start
Synchro-Recording.
To stop CD Synchro-Recording
Press Ml on deck B or the CD player.
"@ You can use an optional remote to operate the CD
player
To start CD play, press Ell twice; to pause CD play, press
Il once; to locate a CD track, press Kd or PPI.
"O If the SYNCHRO button indicator goes off after
flashing three times
The tape cannot be recorded on because the record-
protect tab(s) on the cassette has (have) been removed.
"@ Length of tape used for recording
Tracks ona CD differ in length. Classical music CDs
andi others often have tracks that exceed the recording
time of a single cassette side. In this case, record the
tape manually.
"@ When recording from the middle of the tape
A tape that is inserted and has not been played or
recorded on is assumed by the deck to be a new tape,
even if the present location is in the middle of the tape.
The deck will transport the tape for 10 seconds before
starting CD Synchro-Recording to bypass the portion
corresponding with the leader. To begin CD Synchro-
Recording without the ten-seconds delay, play or record
on the tape for a few seconds before starting the CD
Synchro-Recording procedure.
ev
If
the
tape
ends
during
CD
Synchro-Recording
on
the
7
front
side
of the
tape
(C>
lights
up)
and
DIRECTION
MODE
is
set
to
C—
or
RELAY
Recording
of
the
track
ends
immediately,
the
tape
direction
is
reversed,
and
recording
starts
again
from
the
beginning
of
the
track.
If the
tape
ends
on
the
reverse
side
of
the
tape
(<J
lights
up),
CD
Synchro-
Recording
stops
and
the
CD
player
stops
playing.