Sony TC-WAS8ESA - Advanced Playback Operations; Locating a Track (Multi-AMS; Auto Play;Memory Play)

Advanced Pla yback Operations
ae ee eS
Locating a Track (Multi-AMS/
Auto Play/Memory Play)
You can locate the following/ previous tracks within a
range of 30 tracks (Multi-AMS: Automatic Music
Sensor) or the beginning of a tape quickly (Auto Play).
You can even locate a specific point anywhere on a
tape (Memory Play).
RESET MEMORY RESET
|
<p </> 44 / >>
Note
Check the direction indicator of the deck you use. When you
locate a track on the reverse side (when << lights up), press
the button(s) in the parentheses.
To locate Press
The beginning of the >P (or 44) as many times as you
next or succeeding want during playback.
tracks For example, to locate 2 tracks
(Multi-AMS) ahead, press twice.
The beginning of the <4 (or PP) once during playback
current track
(Multi-AMS)
The beginning of the 44 (or PP) as many times as you
preceding tracks want during playback.
(Multi-AMS) For example, to locate 2 tracks
behind, press three times.
The beginning of a MEMORY on the deck being used
tape (Auto Play} Tepeatedly until “M” disappears in
the display . Then press <4 (or
b>) while holding down > (or
<I),
A particular pointona MEMORY on the deck being used
tape (Memory Play) tepeatedly until “M” appears in the
display. Find the point you want,
then press RESET to reset the tape
counter and to memorize the point.
To locate the memorized point and
start playback, press <#f (or PP)
while holding down > (or <2).
(Press <4 or PP to stop at “0.00”
(TC-WAS8ESA / WA7ESA / WE805S/
WE7055 only) or at “0000” (TC-
WE605S/ WR550Z / WE505 only}. )
Notes
* The Multi-AMS function may not work correctly if:
— the blank space between tracks is less than 4 seconds
long.
— there is a passage of low frequencies or very low
volume within a track. :
— the signal strength of the left and right channels are
very different.
* The Multi-AMS function is inoperative on a deck
whenever the other deck is playing, recording (except
during dubbing), or in pause.
Even if DIRECTION MODE is set to @>, the deck stops
when the current side reaches the end during Multi-AMS
operation.
¢ The tape counters are reset to “0.00” (TC-WAB8ESA /
WAZESA / WE805S / WE705S only) or to “0000” (TC-
WE605S/ WR550Z / WE505 only) when you turn off the
tape deck.