Sony TC-WAS8ESA - Playing a Tape

Basic Operations
Playing a Tape
32
4
¢ See page 4 for hookup
information.
‘e You can use either deck for
playback.
'Q@ To adjust the pitch (Pitch
Control function) (TC-
WE805S/WE705S/WE505
only)
ON DOFF
ONTROL
eX
+
Push in the PITCH
CONTROL button to activate
Pitch Control function and
turn the control clockwise to
raise the pitch or counter-
clockwise to lower it.
You can adjust the pitch
during playback on deck A or
normal-speed dubbing (but
not during RMS play or RMS
dubbing).
To play a tape recorded
with the Dolby NR*
system
Set DOLBY NR to ON and
select the same position that
the tape was recorded in—B,
C, or S (unavailable on the
TC-WES505).
ae
Les You can connect the
headphones to PHONES
* Dolby noise reduction
manufactured under license
from Dolby Laboratories
Licensing Corporation.
“DOLBY” and the double-D
symbo] 00 are trademarks of
Dolby Laboratories Licensing
Corporation.
1 Turn on the amplifier and select the tape deck position.
Press POWER, and then press &
and insert a cassette.
With the side you want to play
facing you
3 Set DIRECTION MODE.
To play back Set to
One side only =
Both sides continuously* cD
Both decks in succession* RELAY
* The deck automatically stops after playing back five times.
Press >.
The deck starts playing. Adjust the volume on the amplifier.
Do not press POWER or & while the tape deck is operating.
If you do so, the tape may be damaged.
~
° Press
Stop playing a
Start playback from the reverse side <J
Pause PAUSE I. Press the button again to
resume play.
Fast-forward or rewind PP or <4 when the deck is stopped
Increase the tape fast-forward or
rewind speed (High-Speed Fast-
Forwarding and Rewinding
functions) (TC-WAS8ESA / WA7ESA/
WE805S / WE705S only}
PP or 44 again during fast-forwarding
or rewinding
Take out the cassette & after stopping playing