Sony TC-WE625 - Inserting a Blank Space During Recording (Record Muting); Synchro-Recording with a CD Player through a Control A1 Cable

16
EN
Advanced Recording Operations
3-862-713-31(1)/CED/SP
DIRECTION MODE SYNCHRO
ª / ·
§
PRr
§
PRr
p
ª·
0
g
)
PAUSE
CLEAR BACK FRONT
REC MUTE
REC
PAUSE
REC MUTE
REC
ON FILTERONOFF
(AMS) (AMS)
0
)
(AMS) (AMS)
p ª·
– RMS +
RMS/START
MEMORY
RESET
MEMORYAB
COUNTER
SET CHECK DISPLAY DECK A DECK B A+B REC HIGH/NORMAL
DOLBY NR
B
C
S
RMS AUTO CAL(STARTP)
DUBBING A B
START(DECK BP)
PITCH CONTROL
+–
ØON øOFF
Aa
RELAY
DIRECTION MODE
AUTO REC LEVEL
FADER ARL
π SYNCHRO
PHONES

0
1
2
3
4
5
6
7
8
9
10
RESET
PAUSE P
REC MUTING R
§
PRr
§
PRr
p
ª·
0
g
)
PAUSE
CLEAR BACK FRONT
REC MUTE
REC
PAUSE
REC MUTE
REC
ON FILTERONOFF
(AMS) (AMS)
0
)
(AMS) (AMS)
p ª·
– RMS +
RMS/START
MEMORY
RESET
MEMORYAB
COUNTER
SET CHECK DISPLAY DECK A DECK B A+B REC HIGH/NORMAL
DOLBY NR
B
C
S
RMS AUTO CAL(STARTP)
DUBBING A B
START(DECK BP)
PITCH CONTROL
+–
ØON øOFF
Aa
RELAY
DIRECTION MODE
AUTO REC LEVEL
FADER ARL
π SYNCHRO
PHONES

0
1
2
3
4
5
6
7
8
9
10
RESET
Synchro-Recording With a CD
Player Through a Control A1
Cable
By pressing SYNCHRO, you can perform synchro-
recording on your tape deck with a Sony CD player
connected to the CONTROL A1 connector through an
optional control A1 cable (see page 4). The control A1
cable supports advanced functions not possible with
the commander-based CD synchro-recording function
on previous models. Further information on the
various operations made possible by a control A1 cable
is provided in the pamphlet attached to this manual.
Inserting a Blank Space During
Recording (Record Muting)
You can insert a blank space of 4 seconds between each
track. The blank spaces allow you to locate the start of
specific tracks afterwards using the Multi-AMS
function (see page 8). You can also use this function to
erase unwanted portions on a tape.
1 Start recording.
2 Press REC MUTING R where you want to insert a
blank space.
“REC” flashes in the display and a blank is
recorded on the tape.
After 4 seconds, P lights up and the tape deck
changes to recording pause.
3 Press PAUSE P to resume recording.
z If you want to insert a blank space longer than 4
seconds
Hold down REC MUTING R as long as you want.
After 4 seconds, “REC” flashes faster.
When you release REC MUTING R, P lights up and the
tape deck changes to recording pause.
Press PAUSE P to resume recording.
1 Set the source selector on the amplifier to CD
player.
2 Insert a CD into the CD player.
3 Select the play mode (CONTINUE, SHUFFLE, or
PROGRAM) of the CD player.
4 Insert a cassette into deck B.
5 Select the side(s) to be recorded on.
6 Select the side you want to start recording from
on deck B.
To record from Press
The front side ·
The reverse side ª
AOnly one side
Both sides
To record on Set DIRECTION MODE to
a or RELAY
6/11-17_TC-WE825S.31(1)EN 8/19/98, 4:25 PM16