1-2. GENERAL OF PVM-14540M
Features
HR (High Resolution) Trinitron picture tube
HR Trinitron tube provides a high resolution picture ..
Horizontal resolution is more than 600 TV lines at the center
of the picture.
Four color systems available
The monitor can display PAL, SECAM, NTSC and NTSCu)•
signals. The appropriate color system is selected
automatically.
• A signal of NTSCw is used for playing back NTSC
recorded video cassettes with a video tape recorder/
player especially designed for use with this system.
Blue only mode
In the blue only mode, an apparent monochrome display is
obtained with all three cathodes driven with a blue signal.
This facilitates color saturation and phase adjustments and
observation of VCR noise.
Analog RGB/component input connectors
Analog RGB or component (Y, R-Y and B-Y) signals from
video equipment can be input through these connectors.
Y/C input connectors
The video signal, split into the chrominance signal (C) and
the luminance signal (Y), can be input through this
connector, eliminating the interference between the two
signals, which tends to occur in a composite video signal,
assuring video quality.
Beam current feedback circuit
The built-in beam current feedback circuit assures stable
white balance.
Comb filter
When NTSC video signals are received, a comb filter
activates to increase the resolution, resulting in fine picture
detail without color spill or color noise.
Automatic termination
(connector with V'v mark only)
The input connector is terminated at 75 ohms inside when no
cable is co1inected to the loop-through output connectors.
When a cable is connected to an output co1mector, the
75-ohms termination is automatically released.
Underscan mode
The sign.ii normally sc.inned outside of the screen can be
monitored in the undersc.in mode.
,~mrw
When the monitor is in the underscan mode, the dark RGB
scanning lines may appear on th~ top edge of the screen.
These are mused by an internal test signal, rather th.in the
input sign.ii.
Horizontal/vertical delay mode
The horizontal and vertical sync signals can be checked
simultaneously in the H/V delav mode.
External sync input
When the EXT SYNC selector is in the on position, the
monitor can be operated on the sync signal supplied from
an external sync generator.
Auto/manual degaussing
Degaussing of the screen can be performed automatically
when the power is turned on, or manually by pressing the
DEGAUSS button.
On-screen menus
You can set color temperature, CHROMA SET UP, .ind
other settings by using the on-screen menus.
Five menu languages
You can select the menu language from among the five
languages on the menu.
EIA standard 19-inch rack mounting
By using an MB-502B (for PVM-1454QM) or SLR-103 (for
PVM-2054QM) mounting bracket (not supplied), the
monitor can be mounted in an EIA standard 19-inch rack.
For details on mounting, see the instruction manual of the
mounting bracket kit.
SDI (Serial Digital Interface) kit
By using SDI kit, the monitor can display SMPTE 259M 4:2:2
serial digital signal from a digital VTR. (ex. Sony 4:2:2 VTR)
SDI kit: 4:2:2 digital video board
Digital audio board
1
- 11 -
To Next Page
Loading...
