Sony Trinitron PVM-14N1E - User Memory Menu

2-5. PICTURE TUBE REMOVAL
2. Connector panel
5. CA board (14 inch)
CB board (20 inch)
S
6. Deflection yoke
7. Four screws N\®
a”
(Tapping screw 5) —¢ |
Pele |
|
|
|
|
|
Remove the two claws
20 inch only
®
8. Picture tube
shield —
9. Picture tube !
1. Anode cap
Cushion
e REMOVAL OF ANODE-CAP
14 inch only
a eCBholde | Fo “I
|
|
|
|
| 4. A board
| |
|
|
|
NOTE:
Short
circuit
the
anode
of
the
picture
tube
and
the
anode
cap
to
the
metal
chassis,
picture
tube
shield
or
carbon
painted
on
the
ficture
tube, after removing the anode.
«REMOVING PROCEDURES
1. Turn up one side of the rubber cap 2. Using a thumb pull up the rubber cap
in the direction indicated by the arrow firmly in the direction indicated by the
®.
arrow
©.
«HOW TO HANDLE AN ANODE-CAP
1. Don't hurt the surface of anode-caps with sharp shaped material!
2. Don't press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the rubber.
3. Don'tturn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
When one side of the rulber cap is
separated from the anodebvitton, the
anode-cap can be remove by turning
up the rubber cap and puing up it in
the direction of the arrow ©.