Sony Trinitron PVM-14N1E - Page 14

amas [Wsize [Hse ——SSS*Y SCE IC
Pin-amp
[Sasi [-HSEXYPIN_| Hi sexypim_ =i SCE «BS
[eaes> [7H COR PIN | conection pin | 48|__ 6D,
fesse] VPO | Initial value for Veenter | 0[ 0)
[cost |VSWE [Vise dT BC
(64) (COMB) ia, for NTSC comb fil- (C3) (C3)
Trimming level for video
<65> |*<DA TRIM> <200>| <200>
output
Exclusive to Each Model
With | Without
DISP. ITEM RGB RGB
MODEL Model selection | 1 [| o |]
Setting for Each Input
DISP. ITEM VIDEO
is 20inch
ANALOG-RGB
*R DRIVE
*G DRIVE
*B DRIVE 1B6 186 1B6 | _186 |
Clamp timing for RGB
enero [ee
*R C/O REF _| Red cutoff reference
*G C/O REF _| Green cutoff reference
*B C/O REF | Blue cutoff reference
Setting for Each Line Frequency
DISP. ITEM 525/60 | 625/50
44)<45>| PMSO_ | Picture measurement stop | F9 | _132 |
Measurement line for beam
(45)<46>| TML
aes
current feed back (The posi-
tion of beam current feed-
back pulse is changeable)
H BLK1 H blanking stop
H BLK2 H blanking start [iO
VBST V. blanking start
Setting for Each Color Standard
NTSC 358 NTSC
aoe bi TRAP 443
A
SECAM
NTSC tint angle | FeF; AS{ oo -[ -[)-]
(49)<50> | L/C DELAY | Luminance/chroma dela
Note:
1. Each IC version has its own displays of service mode. Refer to the
followings.
No mark : common
( ) : Ver 1.20/1.30/1.40
<b : Ver 2.00
{ ]j : for V901 (black CRT)
~~
* V90]1 has been changed from a gray CRT to a black CRT.
Refer to SECTION 8. Electrical Parts List on page 71 for the list of
serial numbers.
2. The data with marking “*” to the name of signal can be changed freely.
The data without marking “*” is a fixed data.