Sony UWP-V1 Service Manual

164 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

UHF WIRELESS MICROPHONE PACKAGE

UWP-V1

UWP-V2

UWP-V6

UWP-X7

UWP-X8

UHF SYNTHESIZED TRANSMITTER

UTX-B2

UHF SYNTHESIZED WIRELESS MICROPHONE

UTX-H2

UHF SYNTHESIZED TUNER UNIT

URX-M2

UHF SYNTHESIZED DIVERSITY TUNER

URX-P2

UHF SYNTHESIZED TRANSMITTER

UTX-P1

SERVICE MANUAL

1st Edition

Table of Contents

Other manuals for Sony UWP-V1

Operating Instructions72 pages

User Manual12 pages

Questions and Answers:

V
Vincent CisnerosAug 13, 2025
Why is there sound interruption or noise in my Sony Microphone system?
- K
  kristen97Aug 14, 2025
  Sound interruption or noise in your Sony Microphone system can occur if the transmitter and tuner are not set to the same channel. Ensure that both are using the same channel. Also, using the same channel for multiple transmitters can cause interference; assign a different channel to each transmitter. Ensure all transmitters are set to channels within the same channel group. If operating multiple UWP series packages, select channels within the same channel group (excluding group 00), and maintain at least a 2-channel interval (250 kHz) between them.
R
Rachel MeyersAug 17, 2025
What to do if there is no sound from my Sony Microphone system?
- R
  Rachel HobbsAug 17, 2025
  If there is no sound from your Sony Microphone system, first check that the channel setting on the transmitter matches the tuner. Next, confirm that the transmitter is turned on and that the RF indicator on the tuner is lit. Ensure the microphone input is selected on the transmitter, not the line input. If using an MB-X6/SRP-X500P, turn it off and on again if the tuner module was installed or uninstalled while it was powered on.
P
Patty StewartAug 21, 2025
How to fix a Sony Microphone system that does not turn on?
- A
  Ariana GilbertAug 21, 2025
  If your Sony Microphone system does not turn on, ensure that the batteries are inserted with the correct polarity. If they are, the batteries may be exhausted, so try replacing them with new ones. Also, check the battery terminals in the transmitter; if they're dirty, clean the + and – terminals with a cotton swab.
C
Chris RodriguezAug 25, 2025
Why do the batteries in my Sony Microphone system drain so quickly?
- T
  tamara11Aug 26, 2025
  If the batteries in your Sony Microphone system are draining quickly, the batteries may be exhausted and need replacing. If you're using manganese batteries, switch to alkaline batteries, as they last more than twice as long. Be aware that UWP series components used under cold conditions may also experience rapid battery drain.
E
Erin RosarioAug 29, 2025
What causes distortion in the sound from my Sony Microphone system?
- R
  Robert VaughnAug 29, 2025
  Distortion in the sound from your Sony Microphone system can be due to several reasons. If the attenuation level of the transmitter is too low, increase it by pressing the + button in attenuation level setting mode. Ensure that the transmitter and tuner are set to the same channel. If you're using headphones, make sure they have a stereo mini jack. Also, verify that the MIC/LINE input selector is correctly set to LINE if you are inputting a line output signal.
M
Mark WilliamsSep 2, 2025
Why is the sound weak on my Sony Microphone system?
- G
  Gary RhodesSep 2, 2025
  If the sound from your Sony Microphone system is weak, first check the attenuation level on the transmitter and decrease it by pressing the – button in attenuation level setting mode. Make sure that the volume on the amplifier or mixer is appropriately adjusted. Also, ensure that the microphone input is selected on the transmitter, not the line input.
G
Gary BaileySep 5, 2025
What does it mean when the RF indicator is on even when the Sony Microphone system transmitter is off?
- A
  Amy BrownSep 5, 2025
  If the RF indicator on the tuner of your Sony Microphone system lights up even when the transmitter is off, it may be due to jamming radio waves. Try locating a channel group that is not affected by these jamming radio waves and switch to that channel group.
K
Kristin SmithSep 9, 2025
How to change the channel on my Sony Microphone system?
- S
  Scott WolfeSep 9, 2025
  To change the channel on your Sony Microphone system, if pressing the SET button alone doesn't work, restart the unit while holding down the SET button. Then, use the + and – buttons to change the channel.

Sony UWP-V1 Specifications

General

Type	Wireless Microphone System
Modulation	FM
Audio Frequency Response	50 Hz - 15 kHz
Signal-to-Noise Ratio	100 dB or more
Frequency Range	UHF band
Operating Frequency	Multiple selectable frequencies
Dynamic Range	100 dB
Total Harmonic Distortion	0.5% or less
Operating Range	Approx. 100m (328 feet)
Power Supply	2 x AA batteries
Battery Type (Transmitter)	AA alkaline battery
Charging Time (Transmitter)	Not applicable
Connector (Receiver)	3.5 mm mini-jack
Operating Temperature	0°C to 40°C
Dimensions (Transmitter)	58 x 98 x 22 mm
Weight (Transmitter)	Approx. 85g (without battery)

Related product manuals

Preview: Sony UWP-D21

Preview: Sony UWP Series

Sony UWP Series

Preview: Sony AU

Preview: Sony DWA-01D