16
Projecting an Image
3 The cursor will disappear if the
adjustment range limit is reached.
Press the RESET key to restore the projected image before adjustment.
Correcting deflection 1-The right/left edges of the image
1 Move the s by using V/v/B/b to select
the corner you want to correct.
If you push ENTER, you can switch to the
cursor display.
2 You can adjust the deflection of the edges
by using V/v/B/b.
You can adjust the central position of the
edges by using V/v. For the range of
deflection, use B/b. You can adjust the
right/left edge independently.
When adjusting the central position of the
edges, the right and left edges will be set at
the same time.
Example of cursor display:
You can adjust in all directions.
You can adjust only to the left/
right or downwards.
Note
Adjust using this cursor.
To Next Page
