17
Projecting an Image
Projecting/Adjusting an Image
3 The cursor will disappear if the
adjustment range limit is reached.
Press the RESET key to restore the projected image before adjustment.
Correcting deflection 2-The top/bottom edges of the image
1 Move the s by using V/v/B/b to select
the corner you want to correct.
If you push ENTER, you can switch to the
cursor display.
2 You can adjust the deflection of the edges
by using V /v/B/b.
You can adjust the top position of the
edges by using B/b. For the range of
deflection, use V/v. You can adjust the
top/bottom edge independently.
When adjusting the top position of the edges,
the top and bottom edges will be set at the
same time.
Example of cursor display:
You can adjust in all directions.
You can adjust only upwards/
downwards or to the right.
Note
Adjust using this cursor.
To Next Page
