To Next PageTo Next PageWhy is the LAMP/COVER indicator flashing on my Sony VPL-CX80?
If the LAMP/COVER indicator on your Sony Projector is flashing, it could be due to the lamp cover or air filter cover being detached. Ensure both covers are securely attached, following the instructions on pages 38 and 39. Alternatively, the lens protector might not be opening correctly; in this case, slide the lens protector by hand and then press the I/1 key.
What to do if my Sony Projector has no picture?
If your Sony Projector displays no picture, ensure all cables are properly connected. Select the correct input source using the INPUT key. If using a computer, set the computer signal to output only to an external monitor. For notebooks or all-in-one LCD types, you might need to switch the computer's output to the projector via specific keys or settings; refer to your computer's operating instructions for details.
How to fix a Sony VPL-CX80 Projector when the power is not turned on?
If your Sony Projector isn't turning on, wait about 60 seconds before attempting to turn it on again if it was recently turned off and on. Ensure the lamp cover is securely closed and that the air filter cover is properly attached.
How to adjust the image size on my Sony VPL-CX80 Projector when it extends beyond the screen?
If the image on your Sony Projector extends beyond the screen, and you've pressed the APA key when there are black edges, display the full image and press the APA key again. You can also adjust the “Shift” settings on the INPUT SETTING menu.
What to do if both LAMP/COVER and TEMP/FAN indicators light up on Sony Projector?
If both the LAMP/COVER and TEMP/FAN indicators light up on your Sony Projector, it indicates a breakdown in the electrical system. In this case, you should consult with qualified Sony personnel for assistance.
How to fix no picture on my Sony VPL-CX80?
If your Sony Projector displays no picture, ensure the cables are properly connected as described on page 17. If you're using a computer, and it's DDC compatible, connect the projector, turn it on, and then start the computer. Also, verify that you've selected the correct input source using the INPUT key, as shown on page 20. Check if the picture is muted by pressing the PIC MUTING key. Finally, make sure your computer signal is set to output to an external monitor as detailed on page 18.
How to fix image extending beyond the screen on Sony VPL-CX80?
If the image from your Sony Projector extends beyond the screen, and you've noticed black edges around the image, press the APA key to display the full image. You can also adjust the “Shift” setting in the INPUT SETTING menu, as described on page 31.
What does it mean when the LAMP/COVER indicator lights up on Sony VPL-CX80 Projector?
If the LAMP/COVER indicator on your Sony Projector is lit, it means the lamp has reached the end of its life and needs replacement, as described on page 37. Alternatively, the lamp might be overheating; wait 60 seconds for it to cool down before turning the power back on.
What to do if the remote commander for Sony VPL-CX80 Projector is not working?
If the remote commander for your Sony Projector isn't working, first replace the batteries, referring to page 15. Then, ensure the COMMAND ON/OFF switch is set to ON. Lastly, verify that the PJ/NETWORK selector switch is set to PJ.
Why is the picture from the INPUT A connector on my Sony VPL-CX80 Projector colored strangely?
If the picture from the INPUT A connector on your Sony Projector is colored strangely, the “Input-A Signal Sel.” setting on the SET SETTING menu may be incorrect. Select “Computer,” “Video GBR,” or “Component” according to the input signal.
General