Sony Walkman MZ-RH1 - Test Mode Functionality Details; Manual Mode Procedures

13
MZ-RH1
3. MANUAL MODE
This is mode to adjust or check the operation of the set by function.
Operation of The Manual Mode
1. Enter the test mode (Display Check mode).
2. Press the [VOL+] key to activate the Manual mode where the
EL displays as shown below.
3. During Manual mode, the optical pick-up moves outward or
inward while the > or . key is pressed for several
seconds respectively.
4. Each test item is assigned with a four-digit item number; 1000th
place is a top item, 100th place is a major item, 10th place is a
medium item, and unit place is a minor item.
Flow of manual mode operation:
x
key
> key
> key
> key
Top item switching
Major item switching
x
key
[VOL +] key: 1000th place of item
number increase.
[VOL --] key: 1000th place of item
number decrease.
[VOL +] key: 100th place of item
number increase.
[VOL --] key: 100th place of item
number decrease.
Medium item switching
x
key
[VOL +] key: 10th place of item
number increase.
[VOL --] key: 10th place of item
number decrease.
> key: 1st place of item
number increase.
. key: 1st place of item
number decrease.
Minor item switching
[VOL +] key: Increases the adjusted
value.
[VOL --] key: Decreases the adjusted
value.
Adjusted value variation
Adjusted value write
[ ] key: Adjusted value is written.
X
5. The display changes a shown below each time the
[DISPLAY/MENU] key is pressed.
*1) It is skipped excluding the item number 5000 less than 8000.
6. To release the Manual mode, press the x key to return to the
Display Check mode.
• Address & Adjusted Value Display
item number
item title
adjusted value
• Jitter Value & Adjusted Value Display
• Block/Bite Error Value & Adjusted Value Display
• ADIP Error Value & Adjusted Value Display
• Focus Drive Value & Adjusted Value Display
• Item Title Display
• Bite Error LPF Value & Adjusted Value Display *1)
• CEMAX Value & Adjusted Value Display *1)
XXXX ******##
item number
address
adjusted value
XXXX ***S##
item number
jitter value
adjusted value
XXXX ***J##
item number
block/bite error value
adjusted value
XXXX ***B##
item number
bite error LPF value
adjusted value
XXXX ***B##
item number
CEMAX value
adjusted value
XXXX ***B##
item number
ADIP error value
adjusted value
XXXX ***B##
item number
focus drive voltage value
adjusted value
XXXX ***B##
0000 Manual