12
MZ-RH1
2. CONFIGURATION OF THE TEST MODE
It shifts from the display check mode to each mode as shown in the
figure below.
Flow of the test mode:
OUTLINE
Operation in the test mode is performed with the set. A key having
no particular description in the text, indicates a set key. Also, For
the display, the EL display on the set is shown.
1. OPERATION IN SETTING THE TEST MODE
• When the test mode becomes active, first the Display Check
mode is selected.
• Other mode can be selected from the Display Check mode.
• When the test mode is set, the EL repeats the following display.
• When the x key is pressed and hold down, the display at that
time is held so that display can be checked.
Display check mode:
SECTION 4
TEST MODE
Display Check Mode
Version display
→
All lit
→
All off
→
Version display...
[VOL +]
key
x
key
x
key
x
key
x
key
x
key
N/ENT
key
>
key
[REC/T MARK]
key
[DISPLAY/MENU]
key
[VOL --]
key
Open the
upper panel
Manual Mode
Sound Skip Check Result
Display Mode (Play)
Self-Diagnosis Result Display Mode
Sound Skip Check Result
Display Mode (REC)
Key Check Mode
Overall Adjustment Mode
Key Count Mode
[DISPLAY/MENU]
key
(press a few
seconds)
Remote commander
[DISPLAY]
key
(press a few seconds)
(Not used in servicing. Return to the display check mode when
entering by mistake)
Ver 1.000 BEr******
0000 Manual
0000 AdjF**
0100 10
0000 1 0000
0000 P00r00
0000 p00R00
0000
Ver 1.000 BEr******
All lit
All off
Microcomputer
version display
To Next Page
Loading...
