– 2 –
TABLE OF CONTENTS
1. GENERAL ................................................................... 3
2. DISASSEMBLY ......................................................... 4
3. MECHANICAL ADJUSTMENTS ....................... 8
4. ELECTRICAL ADJUSTMENTS......................... 8
5. DIAGRAMS
5-1. Block Diagram ................................................................ 9
5-2. Printed Wiring Board ...................................................... 11
5-3. Schematic Diagram ......................................................... 13
6. EXPLODED VIEWS ................................................ 16
7. ELECTRICAL PARTS LIST ............................... 19
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
To Next Page
Loading...
Need help?
General
