Rackmount Kit Mounting Instructions XGS 116(w)/126(w)/136(w)
Please note
This rackmount kit can only be used with XGS 116(w)/126(w)/136(w) models.
What is included in the box
1. Remove existing screws from the chassis
Remove the three screws from each side of the chassis.
2. Attach mounting brackets to the chassis
Please note: You can mount the unit into a rack either with
the front (2a) or the back (2b) facing forwards (see below).
Secure one of the wide mounting brackets on the left side
of the appliance (when looking at the front) and the small
mounting bracket on the right side using three of the flat
head screws supplied for each side.
3. Install the adapter tray
Attach the power adapter tray to the wide mounting
bracket by using four of the supplied round head screws.
4. Install the power adapter
Place the adapter on the tray.
Depending on the adapter type and size used with your
XGS model, place one of the supplied sponges on top of
the power adapter and secure in position with one of the
supplied adapter brackets by using two of the supplied
round head screws.
2 wide mounting brackets (left, rear)
1 small mounting
bracket (right) 2 adapter trays
Please Note: In addition to the rack mounting kit contents, you will need a long-handled Phillips-head screwdriver.
2 adapter brackets
2 sponges
6 flat headed
M3 Screws
12 round headed
M3 Screws
Ports
Wide mounting
bracket
2b. Back-facing installation
LEDs
Small mounting bracket
2a. Front-facing installation
Adapter tray
Bracket
Sponge
1.
3.
4.
To Next Page
Need help?
General
