INSTRUCTION AND SERVICE PARTS MANUAL - FREEZER CS 800, s/n F0176-00 - ALFRED & CO
D7
Compressed air creates certain unavoidable hazards. Compressed air may
retain the power to move objects even after the supply is turned off. Air
operated mechanical devices may operate unexpectedly from a remote
control signal. If the air supply pressure exceeds design limits, plastic line
connections could come apart and move around uncontrolled. These create a
hazard of severe injury to personnel working in the area.
To minimize the risk from these inherent hazards:
• All installation of compressed air must be performed by trained and
authorized pipefitters only.
• All compressed air installation must comply with all applicable codes and
standards.
• Install a hand operated shut-off valve in the supply line to allow isolation
of components before service or maintenance
• DO NOT perform any maintenance or service on the compressed air
system components unless the supply valve to the system has been
closed and locked or tagged.
• Train operating and maintenance personnel to always fully reconnect the
removable air lines used to operate the pump bypass feature.
3.12. CLEANING HAZARD
DANGER !
The use of water around electronic equipment enclosures creates a
hazard of electric shock which could cause severe injury or loss of life.
Turn off the electric power supply and lock out before using any water for
cleaning or rinsing around the electrical enclosures. Be certain the doors
on all electric enclosures are closed and fasteners tightned. Never spray
water directly into any electric controls or enclosures.
DANGER !
To properly clean and sanitize the Continuous Ice Cream Freezer for use
with food products it may be necessary to use chemical solutions. many
of the commonly used chemical used chemical solutions could cause
sever e injury to personnel if contacted. The hazard is especially severe
for eyes, skin or inhalation.
To minimize the risk from these inherent hazard:
• Thoroughly train all personnel working with cleaning or sanitizing
chemicals in their safe handling and disposal following use.
Manual Cleaning Procedure:
• Do not use toxic and/or flammable solvents to clean a machine.
To Next Page
Loading...