Söring SONOCA 185 - 5.4.2 Connecting the irrigation tubing to the instrument

Installation
DocNr.: 03-4655 R03.01 | 22.09.2015 | en-US | Ultrasonic Generator 23
Connecting instruments
Requirements
 The ultrasonic generator is turned on.
 The instrument and instrument cable have been sterilized.
Procedure
1. Insert the instrument cable into the connector socket on the instrument.
Observe the markings.
– The instrument cable engages in the connector socket.
2. Fully insert the instrument cable into the connector socket on the ultrasonic gen-
erator.
Observe the markings.
–The OK indicator light on the ultrasonic generator goes on.
5.4.2 Connecting the irrigation tubing to the instrument
Requirements
 The instrument cable is connected to the instrument.
 The irrigation tube has been sterilized.
Procedure
1. Connect the irrigation tubing with the luer lock port or instrument irrigation.
Hand tighten only.
– The irrigation tubing is connected to the instrument.
out.fm Seite 23 Dienstag, 22. September 2015 3:24 15