Söring SONOCA 185 - Disconnecting the Ultrasonic Generator from the Main Power Supply

Operation
34 Ultrasonic Generator | DocNr.: 03-4655 R03.01 | 22.09.2015 | en-US
Ending treatment
6.3.5 Disconnecting the ultrasonic generator from the main power supply
Requirements
 The ultrasonic generator is turned off.
Procedure
1. Disconnect the power cord from the main power supply and then from the ultra-
sonic generator.
2. If required, disconnect the potential equalization cable from the potential equal-
ization rail and then from the ultrasonic generator.
– The ultrasonic generator is disconnected from the main power supply.
out.fm Seite 34 Dienstag, 22. September 2015 3:24 15