Operation
32 Ultrasonic Generator | DocNr.: 03-4655 R03.01 | 22.09.2015 | en-US
Ending treatment
6.3 Ending treatment
After treatment, the ultrasonic generator must be turned off. The instrument must
then be disconnected and the accessories must be detached from the ultrasonic gen-
erator.
6.3.1 Turning off the ultrasonic generator
Procedure
1. Turning off the ultrasonic generator using the power switch.
– The ultrasonic generator is turned off.
6.3.2 Disconnecting the instrument from the ultrasonic generator
Following treatment, the instrument must be disconnected from the ultrasonic gen-
erator. Disposable accessories must be disposed of immediately. The instrument and
the instrument cable must then be processed.
Disconnecting the instrument cable
Requirements
The ultrasonic generator is turned off.
Procedure
1. Disconnect the instrument cable from the instrument.
To do this, pull only on the grip sleeve of the instrument cable.
2. Disconnect the instrument cable from the ultrasonic generator.
To do this, pull only on the grip sleeve of the instrument cable.
– The instrument cable is disconnected.
Disconnecting the irrigation tubing
Procedure
1. Close the roller clamp on the irrigation tubing.
2. Disconnect the irrigation tubing from the luer lock on the instrument.
– The irrigation tube is disconnected from the instrument.
– The instrument is disconnected from the ultrasonic generator and the irriga-
tion system.
out.fm Seite 32 Dienstag, 22. September 2015 3:24 15
To Next Page
Loading...
