Sorma BSS-134 - Page 35

8
ELECTRIC PANEL
BSS-134
CHAP.- 8
F1 MANUAL RUN = carry out manual operation.
F2 AUTOMATIC RUN = select one program, set up and display the working conditions relative to the
program selected.
F3 MACCHINE CONFIGURATION = set up the machine.
F4 TIMER/COUNTER SETTING = set up the machine cycle time values.
F5 SORMA = only for the SORMA technicial support.
After powering up the electric control panel, the terminal VT is enabled and turns on the display
showing the main page.
Press to access the following page 2.
N.B.= everytime you press , you will go back to page 2.
N.B. = After about 1 min. the VT display turns off if it is not used.
To turn it on again, just
gently touch it.