Sorma BSS-134 - Page 71

,
MAITENANCE E CLEANING
BSS-134
CHAP.- 10
Cleaning of compressed air fi lter
1) Loosen the cup containing the air fi lter.
2) Remove the fi lter and clean it using compressed air.
3) Assemble the fi lter again and tighten the cup.
Check belts
The belts and the chains must be periodically checked. Check tensioning and wear.
Remember that for every transporter a belt is present which transmits the motion from the gearmotor
to the conveyor belt.
To adjust the tension of the transmission belt the fastening screws of the gearmotor must be loosened,
so that the same can move using the appropriate adjustment slots. The adjustment of the belt of the
gearmotor must be such to allow the fl exion of the same belt at a maximum of three millimetres in
the central area.
Check sliding bars
Proceed with relative greaser inserting lubricant inside the greasers.
Cleaning of frame
Clean the doors and frame using a cloth slightly damp with clean water.
Package evacuation band cleaning
Remove any fruit, soil or other kind of deposits by using a scraper, a damp cloth and compressed air.
Cleaning the fruit feeding hopper
Remove any fruit, soil or other kind of deposits by using a scraper and compressed air.
Cleaning the sealing units
Cleaning of fans/exchangers fi lters
WARNINGS: the intervention frequency very much depends on the environment in which it is positioned
the electric control board; if particular dirty or dusty, frequency must be increased.
1) Dismantle the plastic cap of the fi lter on the electric control board.
2) Remove the fi lter and clean it using compressed air.
3) Assemble the fi lter and cap again.