43
© Sortimo International GmbH
Narrow roof vent
Danger!
It must be ensured that the roof vent is always free and not obstructed due to dirt, snow or dust.
Otherwise, the ventilation effect is restricted or no longer present.
The floor vent must not be blocked/obstructed by parts of the load, e.g. packages, or closed by
adhesive film. Otherwise, the ventilation effect is restricted or no longer present.
Information!
The narrow roof vent is placed towards the front for heavy gases and towards the rear for light
gases.
Rotating the roof vent:
• Remove upper shell (A) by unscrewing the oval head screw (B).
• Press the retaining lugs on the lower shell (C) together and pull them upwards at the same
time.
• Clean sealing ring (D) and contact surface on roof.
• Rotate the roof vent by 180° and press it with the sealing ring (D) into the cut-out; the lower
shell (C) must engage completely into the roof.
• Visually check whether all retaining lugs are snapped in.
• Screw on upper shell (A) using oval head screw (B).
To Next Page
Loading...
Need help?
General
