Starting The Automation
Switching On
When the console is switched on the LCD display (the screen) will illuminate. The
system will then execute several routines and checks, and it displays its progress on
the screen.
If there is a system disk in the floppy drive, the automation will load the program
from the floppy disk into RAM and will then run it. If you hold down the Setup
button, within approximately 5 seconds of power on, the program will also be copied
to the hard disk, and the previous version will be deleted from the hard disk: you
will know if you have pressed Setup within the time allowed because its LED will
light up.
If there is no floppy disk in the floppy drive, the automation will load the program
from the hard disk into RAM and will then run it.
4.114 DC2020 Automated Mixing
To Next Page
Loading...
Need help?
General
