SOUNDMASTER UR190 - Using the Alarms

UR190 / English Instruction Manual
6
Displaying RDS information
Radio Data System (RDS) is a service that allows FM stations to transmit additional information. When you tune to
an FM radio station that transmits RDS signals, the station name is displayed.
Press “INFO” (6) repeatedly to cycle through the following RDS information (if available).
 Radio text
 Program type (such as NEWS, SPORT, POP M)
 Program service
 Mono/Stereo
 Time
 Date
Using the FM menu
1. In FM mode, press “MENU” (3) to access the FM menus.
2. Rotate “SELECT“ (12) to cycle through the below options.
 Scan setting
 System
See below for details of each option.
Scan setting
1. Press “SELECT“ (12) to confirm the selection “Scan setting”.
2. Rotate “SELECT“ (12) to cycle through the below options.
 “Strong stations only”: Search for strong stations only.
 “All stations”: Search for all stations regardless of the signal strength.
3. Press “SELECT“ (12) to confirm the selected option.
System
See chapter “System menu” for details.
USING THE ALARMS
Setting alarms
The radio lets you have 2 alarm settings.
To set the alarm:
1. Press „ON/OFF” (1) to turn the radio on, press “ALARM” (4) to select between Alarm 1 and Alarm 2 and then
press “SELECT“ (12) to confirm the selection.
2. Rotate “SELECT“ (12) to set the hour time of the alarm and then press “SELECT” (12).
3. Rotate “SELECT“ (12) to set the minute time of the alarm and then press “SELECT” (12).
4. Rotate “SELECT“ (12) to cycle through the duration options and then press “SELECT“ (12) to confirm the
selection.