SA263 Collider Delay+Reverb Owner’s Manual
Connecting the Pedal
Power
To power the unit, connect the included 9V DC power supply to the jack labeled DC 9V on the back
panel.
Warning: Using a non-Source Audio supply, especially an unregulated supply, could damage the unit.
A power supply with insufficient current levels may also cause noise or other unpredictable behavior.
Please be very cautious when using 3
rd
-party power supplies and refer to the power supply
requirements printed on the bottom of the Collider’s housing.
Connections
Guitar/Audio Connections
Using standard ¼” mono cables, connect your guitar, bass, or other instrument to the INPUT 1 jack
and your amp (or the next audio device in the signal chain) to the OUTPUT 1 jack. If you have a second
amp, connect it to OUTPUT 2.
When the power and audio connections have been made, Collider is ready for use.
To Next Page
Loading...
