Controls
Rotary Encoder Knob
This is the key to the whole operation. Push + rotate the Encoder Knob to select a frequency band.
Turn the Encoder Knob clockwise or counterclockwise to boost or cut the selected band. Double tap
the Encoder Knob to “start over” and set the bands back to flat. Push + hold the Encoder Knob to
enter the Options screen.
OUTPUT Knob
Think of this knob as a master volume control. Rotate this knob to boost your signal +12 dB or cut
your signal down to -∞ dB (zero volume). The OUTPUT Knob is lit with a bright blue LED, which will
glow brighter the higher the knob is turned up. When adjusting the knob, the blue LED and Activity
LED will flash twice to indicate when “unity” has been reached. Unity gain, or 0dB, is set to be the
mid-point of the OUTPUT knob range.
Footswitch
By Default, click the footswitch to engage or bypass the pedal. Hold the footswitch down while the
pedal is bypassed to scroll through presets. Release when you’ve reached your desired preset. The
press + hold actions in both engaged and bypassed states, as well as double-tap actions can be
changed in the Hardware Options.
To Next Page
Loading...
