External Loop 2 -> Loop 1
This routing mode supports a use case that involves placing two different EQs at two different points
in your signal path. In this routing mode, a loop for external effects is placed after Channel 2, before
Channel 1. INPUT 2 and OUTPUT 2 act as “Send” and “Return” for the effects loop.
Preset Storage and Recall
User Presets store all user editable parameters. This includes the knob positions, parameter settings,
frequencies, routing options, external control, and the full list of Neuro/MIDI accessible parameters.
Included in every preset are settings for either output curve (Channel 1 [Mono] or Channel 2). After a
preset is recalled, you can always tweak the Output in a performance situation by turning the knob.
The knob parameter will then “jump” to the current knob position as it is rotated.
Recalling Presets
The first four User Presets (or eight in Preset Extension Mode) are accessible via the onboard
hardware or with an external footswitch in the following ways:
1. Click the SELECT button to cycle through the hardware user presets. This function works
whether the pedal is engaged or bypassed.
2. By default, when the effect is bypassed, press and hold down the footswitch to cycle forward
through presets. Release when you’ve arrived at your desired slot. If the pedal is engaged, you
will not be able to cycle through presets.
This behavior can be switched in the Neuro App and Neuro Desktop Editor’s Hardware Options
for the EQ2, so you can cycle through presets while the pedal is engaged rather than bypassed.
Recalling MIDI Presets
All 128 available User Presets are accessible with an external MIDI controller. MIDI controllers can be
connected via either the 5-pin DIN (MIDI IN) jack on the side of the pedal, the USB port at the top of
the pedal, or through a Neuro Hub, which connected to the CONTROL INPUT at the top of the pedal.
All 128 User Presets can be recalled with the corresponding MIDI program change (PC) messages.
Note: When recalling presets via MIDI PC messages, you may wish to queue up your preset with
effect bypassed. To do this, simply engage the preset, bypass it with the footswitch, then re-save the
To Next Page
Loading...
