SA244 L.A. Lady Overdrive User’s Guide 26
Burn
The Burn command takes the current sound that is running in the hardware and “burns” it to the
internal memory for later use. Burn works as a “what you hear is what you get” type of control; it will
save all of the settings in their current state, as you hear them, and put those into memory. This will
not necessarily match the exact settings shown in the Sound Editor for all parameters unless you
have performed a Send All command first.
After selecting the Burn command, a list of target locations in memory is displayed. There are a total
of 4 options: the 3 factory slots that correspond to the effect selector switch, and the 1 slot in preset
memory.
Replacing an Effect on the Effect Switch
It is possible to replace one of the main effect types with one of the extended effect types or with a
user-created sound. To do this, follow these steps:
Load the sound in the Sound Editor.
Hit the Send All button.
Hit the Burn button.
Select one of the Effect Selector Switch positions to overwrite it.
To Next Page
Loading...
