Introduction SY-5EMM
25
1. Onboard Serial Port COM1,COM2
External peripherals that use serial transmission scheme include:
- serial mouse,
- and modem.
Plug the serial device cables directly into the COM1or COM2 9-pin
male connector located at the rear panel of the mainboard.
2. Parallel Port PRT
This parallel port is used to connect the printer or other parallel
devices.
Plug the parallel device cable into the 26-pin female connector
located at the rear panel of the mainboard.
3. PS/2 Keyboard
Plug the keyboard jack directly into the 6-pin female PS/2 keyboard
connector located at the rear panel of the mainboard.
4. PS/2 Mouse
Similarly, plug the mouse jack directly into the 6-pin female PS/2
mouse connector.
5. Universal Serial Bus USB1/USB2
This mainboard provides two USB ports for your additional devices.
Plug the USB device jack into the available USB connector USB1 or
USB2.
- USB devices under Win98 are allowed.
- With Win95, use the flow HCI V1.1 specifications.
To Next Page
Loading...
Need help?
General
