Hardware Setup SY-6BA+
16
1. Onboard Serial Ports COM1/COM2
External peripherals that use serial transmission scheme include:
- serial mouse,
- and modem.
Plug the serial device cables directly into the COM1/COM2 9-pin
male connectors located at the rear panel of the Motherboard.
2. Parallel Port PRT
This parallel port is used to connect the printer or other parallel
devices.
Plug the parallel device cable into the 25-pin female connector
located at the rear panel of the Motherboard.
3. PS/2 Keyboard
Plug the keyboard jack directly into the 6-pin female PS/2 keyboard
connector located at the rear panel of the Motherboard.
4. PS/2 Mouse
Similarly, plug the mouse jack directly into the 6-pin female PS/2
mouse connector.
5. Universal Serial Bus USB1/USB2
This Motherboard provides two USB ports for your additional
devices. Plug the USB device jack into the available USB connector
USB1 or USB2.
- USB devices under Win98 are allowed.
- With Win95, use the flow UniversalHCI specifications.
To Next Page
Loading...
Need help?
General
